 |
 |
 |
|
J&Ms new 7 round drivers are the largest diameter speakers that
can be installed into the Harley RoadGlide style fairing, and vented
lower fairings, with cone volume and mass comparable to a 6X9 speaker.
J&M's 5 " round drivers are the largest & most efficient
speakers you can install into the rear trunk pod position on the Harley
RoadGlide Ultra.
Both specd at 2 ohms impedance and 140/120+ watts max power, these new
speakers provide the ultimate in bass response, extended mid/high
frequency range and raw audio power.
They feature a waterproof injection-molded polycarbonate woofer cone,
high-flux strength but light-weight dual-donut Neodymium magnet, high
efficiency voice coil, the latest design grillwork with mounted tweeter
and midrange, (plain grills only for LOWER fairing speakers) and
top-quality adapter rings/bracket hardware for secure and clean mounting
into the RoadGlide Ultra.
These are THE most efficient speakers you can buy for your Harley and
their mounting hole pattern and spade electrical connections are exactly
the same as the factory specification.
Lower fairing speaker housings are custom molded to fit the late model
VENTED lower fairing shells, as mounted on the 2011-2013 Harley
RoadGlide Ultra.
This exciting new J&M 4-channel 360w fairing/rear speaker amplifier
kit has been design specifically for use in the 2011-2013 Harley
RoadGlide Ultra fairing with the Harley HK radio.
This is a full range class D amplifier and is specd at 90watts RMS per
channel X4 channels, (360w total) driven continuous into a 2 ohm load @
14.4vdc.
Amplifier mounts inside the fairing using the custom made stainless steel bracket system.
Amplifier gain adjustments are factory preset for this 6 speaker
configuration on the Harley RoadGlide Ultra, along with the custom
in-series wiring harness for the front upper/lower fairing speaker
positions.
Custom made plug-n-play wiring harnesses are included with this
amplifier kit, top quality heavy gauge power/ground wires are used for
the fused battery connection, along with all necessary mounting hardware
& complete installation/operation instructions.
Amplifier itself measures 7 1/4" X 4 X 1 .
|
|
|
 |
|
 |
|